
Press containers and skips
Press containers, BTE hook-lift plant and stationary presses for the depot, with skips and loaders sized to real flows and haul cycles.

When payload, route and container type are tight constraints, you need a refuse compactor sized to the service: Bunder selects mini compactors and side-loading and rear-loading refuse compactors from specialist manufacturers, on two-axle, three-axle and four-axle chassis or bespoke layouts.
A refuse compactor is a collection vehicle with a closed body and a compaction system. The container is emptied into the hopper by hand or with a bin lifter; a blade or plate pushes waste into the body and reduces volume. The vehicle collects more waste per round and tips at the treatment plant less often. Loading can be side, rear or, on smaller units, manual.
Where access is tight or collection is door-to-door, smaller units are often used as satellites to a larger compactor. Models and payloads are assessed against the service route.
A side-loading compactor suits street collection with stationary bins and, when route and grab geometry align, single-operator cycles. A rear-loading compactor offers more flexibility for drop-off modes, bin lifters and satellite transfer. The choice follows the collection model, not tram volume alone.
For a deeper operational comparison, read our side vs rear loading insight.
Axle configuration affects gross weight, payload, footprint and manoeuvrability. A two-axle compactor can fit narrow access; a three-axle compactor often extends payload on dense rounds; four-axle or multi-axle bodies serve tenders that need higher capacity and weight distribution. We size body, compaction and chassis against waste density and haul distance.
Tenders often specify side-loading two-axle, side-loading three-axle, rear-loading two-axle or rear-loading three-axle refuse compactors, with bin lifters or washers. There is no single valid mix for every municipality: we cross-check waste stream, frequency, containers and road constraints before quoting models and lead times.
For a quote or tender, share waste type, crew size, bins or containers planned, required gross weight and whether you need rental or purchase. We reply with matching configurations and supply timing.
Frequently asked questions
A side-loading compactor suits street collection with stationary bins; a rear-loading unit offers more flexibility for drop-off modes and bin lifters. For a broader operational comparison, read the Bunder insight on side vs rear loading.
It depends on gross weight, payload, footprint and tender rules: on this page see the section on two-, three- and four-axle layouts for the combinations most often specified in tenders.
As well as supply, Bunder can assess rental when the project or tender allows it. For options and availability, see the insight on buying and renting waste collection equipment.
Explore other Equipment & vehicles categories.

Press containers, BTE hook-lift plant and stationary presses for the depot, with skips and loaders sized to real flows and haul cycles.

We handle loading and unloading at depots with loaders, grab cranes, multi-skip units and truck-mounted cranes.

We offer Mattiussi Ecologia bins and kits for home separation, with reusable bags and accessories you can configure by fraction and capacity.
Guides and articles linked to this solution: operational context, design choices and useful references.

Comparing side-loading and rear-loading refuse compactors: bins, crew, road layout, fleet and service organisation. Bunder guide to choosing a system.

A guide for municipalities and operators: how the grab arm of an automatic side-loading compactor works, which bins it lifts and what to put in the tender.

How to evaluate a refuse compactor for collection: service model, bins, routes, chassis, payload and technical requirements.